MAGICINFO DIGITAL SIGNAGE SUPPORT FORUM
Digital Information Displays (Digital Signage) => MagicInfo => Topic started by: lauriercomputer on December 09, 2009, 03:29:19 PM
-
Hello,
I've set up a Screen to run a slideshow with about a dozen images (10 seconds each), now I'd like to add more and make the whole thing last longer, but I can't seem to add time to it... Right now, it runs for 2 minutes. If I try to change to "000230" for instance, it won't even let me type any digits after 0002!
What am I doing wrong?
Also, since I am *very* new at this, is there a better way of creating simple slideshows *in* MagicInfo? Should I just give up and use Adobe Flash instead? ;)
Thanks in advance!
Marty
-
Hi,
I had the same problem couple of weeks ago.
You need to change the duration on the background (0003 for 3 minutes) area before the office area
but you cannot enter seconds only minutes are alowed because you cannot shedule less than a minute
Bob
-
Well son of a... GAH!
I've only been using this for a week, but I've already come up with a list of suggestions a mile long! :D
Thanks so much!